Unlacquered Brass "Neal" Cabinet Knobs and Pulls Cabinet Hardware
Unlacquered Brass "Neal" Cabinet Knobs and Pulls Cabinet Hardware - Round Knob with Base is backordered and will ship as soon as it is back in stock.
This is the unlacquered brass version of our Neal collection of knobs and pulls. This is for clients specifically searching for unlacquered brass that may patina over time. This is a timeless and beautiful collection for all your specific design needs. Comes with screws.
Dimensions
Round Knob with Base
Knob Diameter: 1-1/4"
Base Dimensions: 3/8"
Round Knob
Knob Diameter: 1-1/4"
Base Dimensions: 5/8"
Whistle Knob
Base Dimensions: 1-1/4"
Knob Diameter: 1-1/4"
T-Knob
Base Dimensions: 5/8"
Overall: 1-5/8"
Knob Diameter: 1/2"
Off-Centered T-Knob
Base Dimensions: 5/8"
Overall: 2"
Knob Diameter: 1/2"
3-1/2" Drawer Pull
Center to Center: 3-1/2"
Overall Length: 4-1/8"
4" Drawer Pull
Center to Center: 4"
Overall Length: 4-5/8"
5" Drawer Pull
Center to Center: 5"
Overall Length: 5-5/8"
6" Drawer Pull
Center to Center: 6"
Overall Length: 6-5/8"
8" Drawer Pull
Center to Center: 8"
Overall Length: 8-5/8"
10" Drawer Pull
Center to Center: 10"
Overall Length: 10-5/8"
12" Drawer Pull
Center to Center: 12"
Overall Length: 12-5/8"
Appliance Handles
12" Appliance Pull
Overall Length: 12-15/16"
Projection: 1-7/8"
Hole Spacing: 12"
Base Dimensions: 15/16"
15" Appliance Pull
Overall Length: 16"
Projection: 1-7/8"
Hole Spacing: 15"
Base Dimensions: 1"
18" Appliance Pull
Overall Length: 18-15/16"
Projection: 1-7/8"
Hole Spacing: 18"
Base Dimensions: 15/16"
How to measure cabinet hardware?
To measure cabinet hardware like handles or pulls, you mainly need to know the center-to-center (C-C) measurement—the distance between the centers of the two screw holes. Here’s a quick guide:
For Pulls (Handles):
Measure from the center of one screw hole to the center of the other. This is usually given in millimeters or inches (e.g., 96 mm or 3-3/4").
Tip: Don’t measure the total length unless specified—it’s not the same as the center-to-center distance.
For Knobs:
No measuring is needed for hole spacing—just check the knob’s diameter and projection (how far it sticks out from the cabinet).
Questions?
Questions?
Email us at hello@forgehardwarestudio.com
Are you a trade professional?
Are you a trade professional?
Join our trade program here.