Door Flush Pull and Handle Front and Back Hardware for Interior Doors
Door Flush Pull and Handle Front and Back Hardware for Interior Doors - Satin Brass / Narrow Handle is backordered and will ship as soon as it is back in stock.
- This new flush pull is the perfect low profile, thru-mount solution for barn or sliding door applications. Constructed from brass and available in many finishes.
- This listing is for a set of two items: a flush pull and door pull which are intended to be used together on one door.
- From the drop-down menu you can select the finish and the style of the handle. The flush pull is only offered in one style but you can select the handle style, which is offered in two sizes (which vary in projection and width as noted below).
Narrow Handle
Distance between mounting holes: 8"
Overall Length: 8-9/16"
Bar Width: 13/16"
Projection: 1-13/16”
Wide Handle
Distance between mounting holes: 8"
Overall Length: 8-5/8"
Bar Width: 1-1/16
Projection: 2-1/8”
Flush Pull (Opposite Side)
Width: 2"
Length: 10"
Mounting Holes: 8" apart
How to measure cabinet hardware?
To measure cabinet hardware like handles or pulls, you mainly need to know the center-to-center (C-C) measurement—the distance between the centers of the two screw holes. Here’s a quick guide:
For Pulls (Handles):
Measure from the center of one screw hole to the center of the other. This is usually given in millimeters or inches (e.g., 96 mm or 3-3/4").
Tip: Don’t measure the total length unless specified—it’s not the same as the center-to-center distance.
For Knobs:
No measuring is needed for hole spacing—just check the knob’s diameter and projection (how far it sticks out from the cabinet).
Questions?
Questions?
Email us at hello@forgehardwarestudio.com
Are you a trade professional?
Are you a trade professional?
Join our trade program here.